Renard based Servo ...
 
Notifications
Clear all

Renard based Servo controller

51 Posts
16 Users
0 Reactions
33.5 K Views
Posts: 2214
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago
[#11441]

Here's something I've been working on. It's a Renard based servo controller. I ran the initial(very limited) tests on it tonight and it's working! I do want to redo it a bit to make it easier to etch and to make the headers more secure. I also need to test it in line with a Renard controller to make sure that works but I won't get to that until next week.
I tried to create the controller using similar parts to the Renards. It uses a pic16f688, the same oscillator, rs485 chips, etc. as the Renard SS. Right now it's running at 57600 baud but I've only tested 2 servos at a time(that's all I have right now). As long as the rest of the testing goes well it will be able to control 8 servos.
I also need to clean up the code a bit. The UART section I've just taken from the current Renard code and modified it bit(thanks for doing the hard part Phil:)).
Anyway, enough rambling for now.

5/27/2011 - I have placed an updated version of the Renard Firware in the File Library. If you're using the firmware in this controller there is no need to update the firmware but if you're using the firmware in a Renard controller the update might be beneficial for you. The new software includes remapping the outputs to the origional Renard outputs and allows for Negative outputs.


50 Replies
Posts: 448
(@bobkeyes)
Honorable Member
Joined: 17 years ago

That's great! Just what I need. Will you make it available to the forum? I'd like to make about 6 of them.

Thanks and great job.


Reply
Posts: 919
(@scorpia)
Noble Member
Joined: 19 years ago

Thats an awsome little board,

i will be interested in seeing more information once you have tested it some more.

Peter


Reply
Posts: 2214
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago
bobkeyes wrote:That's great! Just what I need. Will you make it available to the forum? I'd like to make about 6 of them.

Thanks and great job.

Absolutely! I just need to clean it up and test it some more.


Reply
Posts: 2214
Topic starter
(@ctmal)
Famed Member
Joined: 19 years ago
scorpia wrote:Thats an awsome little board,

i will be interested in seeing more information once you have tested it some more.

Peter

Thanks, I'll put all everything up once I clean it up.


Reply
Page 1 / 11
Share: