New Controller desi...
 
Notifications
Clear all

New Controller design

131 Posts
26 Users
0 Reactions
44.7 K Views
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

Dirk - there is a vixen setting that causes the intensities to be displayed (and entered) as integers between 0 and 255, rather than between 0 and 100. And I think (but am not sure) that when you specify a ramp, that the intermediate interpolated values are actually integers between 0 and 255.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

As I see it, the whole reason for more dimming levels is to enable dimming curves to be implemented in a meaningful way. Without the dimming curves the additional levels are useful only for very slow ramps, as far as I can determine.

EDIT - it has always been my unwritten assumption that dimming curves and more dimming levels go hand-in-hand, and that one without the other is not particularly useful. My apologies for not making this more explicit earlier in the discussion.


Reply
TimW
Posts: 554
 TimW
(@timw)
Honorable Member
Joined: 19 years ago

Yes! And the purpose of more dimming levels is about linearity... not more levels of control.

For serial driven controllers I think it makes more sense to implement the correction (eg gamma correction) in the controllers because the bottleneck is not in the controller speed... its in the 'pipe'.


Reply
Posts: 3650
Topic starter
(@jhinkle)
Famed Member
Joined: 15 years ago

I suspect the scenario you mention Phil is what the RGB LED guys are also doing as applying the same voltage to a RED, BLUE, WHITE or GREEN LED will produce different perceived light intensity - beside the physics of the LED itself, our eyes also perceive them differently.

Suggestion:

I don't have my light meter with me --- but from an engineering perspective -- take a light string a measure the intensity at different PWM (assuming AC) levels - they won't be linear - as Phil stated above.

Use those values as an index into a translation array with values that produce the desired curve.

In Vixen 3 - this translation is super simple.

Identify a color with a channel and a translation array for that color.

When Vixen gives you the value - use it as the index into the color's translation array and output that value.

You can manipulate any color or channel you like.


Reply
Posts: 2168
(@djulien)
Noble Member
Joined: 19 years ago
P. Short wrote:I'm not sure if the PIC16F688 has enough bandwidth to do 10-bit or 12-bit dimming, although I can't be sure without coding things up.

Depending on how the code is written, I think you could get 10-bit or higher raw resolution as long as the next closest used dimming level is several steps below the previous one.

don


Reply
Page 5 / 27
Share: