Low-Amp SSR
 
Notifications
Clear all

Low-Amp SSR

37 Posts
15 Users
0 Reactions
25.3 K Views
dirknerkle
Posts: 10310
Topic starter
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
eswets wrote:are you going to put this in the copper file of the library? I would like to make one to try it. would work good for arches!

The design I threw together was a prototype proof of concept and as such, I took some really *dumb* shortcuts. It's not a good idea to put this one out there, but.... I'll revise it and put something in the file library that will be a better solution, still without power triacs... May get to it tomorrow afternoon...


Reply
mrpackethead
Posts: 2289
(@mrpackethead)
Famed Member
Joined: 19 years ago
David_AVD wrote:Nobody else seems concerned by the lack of LV / HV clearance?

Not me, cause i'm not going to build one, and take on that kind of risk.. easy way not to have to be concerned.


Reply
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago

I just couldn't say nothing about the clearance issues.


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

The easiest way to fix the clearance issues on this board is to split the output into 8 neutrals and 8 channels. That way, you could feed the power to the optos from the high voltage side. That just leaves the three spots where the low voltage signal is under the optos; I think you could move the resistors a bit to fix that. Remember that the resistor can go to either side of the LED in the opto; that may also help routing.

As a rule of thumb, you need to keep the low and high voltage sides separated by at least 1/4" (6.4mm) unless you are conformally coating the board.
/mike


Reply
DIY Sparks
Posts: 240
(@diy-sparks)
Reputable Member
Joined: 16 years ago
David_AVD wrote:Nobody else seems concerned by the lack of LV / HV clearance?

I certainly do, but as dirk relates: if you have to, you have to.

I bench repair (or attempt to) lots of eclectic boards from laptops to 1960's fire alarms. The lack of safety or regard to high voltage traces -sometimes just copper bars! -on the old stuff makes me appreciate your concern. When it's a "you gotta be kidding!" situation, I use either liquid tape or corona dope. Each are an easily-controllable brush on insulator with superior dialectric properties. Adding an IC socket, when it applies, gives that extra height and convenience that at least lets me sleep at nights.


Reply
Page 3 / 8
Share: