Great project! I'm not sure how I missed it up until now. I will be adding additional capacity for next year and will be building some of these along with a number of output options. Has there been any thought to a single receiver with local power input? Something like that would be handy in my setup. If not, I'll lay one out.
I was perusing the KiCad files and noticed that the schematic components aren't lining up with any of the standard snap grids. Were special settings (other than 50 mil) used in EESchema? Dumb question I know, but it's giving me all sorts of grief since nothing wants to snap to pins...
smccoy wrote:I was perusing the KiCad files and noticed that the schematic components aren't lining up with any of the standard snap grids. Were special settings (other than 50 mil) used in EESchema? Dumb question I know, but it's giving me all sorts of grief since nothing wants to snap to pins...
You can change the grid spacing. Not everyone uses 50 mil as their default grid. Most use it for general placement, then drop it to 5 or 1 mil for final alignment. Especially us OCD types that have to perfectly place every component.
Correct. I change it all the time when aligning parts on boards, but in schematic layout, where there is no snap-to-pin and with most symbols using 50 mil pin spacing, it's helpful to know what grid was used if not the default. Most of the pins don't seem to be aligning with any of the standard grids so I figured I would ask to make sure I wasn't missing something specific to these.
I have made a "Single_Receiver_Out" PCB. It uses two pins for data, 2 pins for power, and 2 for ground. The sender PCB is the "Pwr_Diff_Expansion". The power can be sent over the cat5 pins for both the Single_Receiver PCB and pixels or you can power the PCB by backfeeding the pixel ports power pin. I plan to use if for pixel I am installing in my screen porch.
Thanks,
Scott
