Quick question. Are the holes on the PB16 board the same layout as any of the "well known" controllers? In other words, is there an enclosure mounting plate that's designed for a different board that would work for the PB16. I am aware of the CG1500 Mounts that are linked in the first post of this thread. Just wondering if there is another easy option...
jleiwig wrote:Wait...it can't be official. It's not blue! I thought they had to be blue?
I order this board during Chinese new year, and JLC was only doing green PCBs because of low staffing.
Glycerine wrote:Quick question. Are the holes on the PB16 board the same layout as any of the "well known" controllers? In other words, is there an enclosure mounting plate that's designed for a different board that would work for the PB16. I am aware of the CG1500 Mounts that are linked in the first post of this thread. Just wondering if there is another easy option...
I did not intentionally make the hole pattern match any other controllers. The mounting holes are spaced on a one inch grid to work with the CG1500. The horizontal distance between the holes is the same as the sandevice but the vertical is one inch less.
scooter_seh wrote:I did not intentionally make the hole pattern match any other controllers. The mounting holes are spaced on a one inch grid to work with the CG1500. The horizontal distance between the holes is the same as the sandevice but the vertical is one inch less.
:thup2: Ok, thanks!
Is the Expansion Header notch on the "Four Out" silk screened upside down as it appears different orientation then the other expansion boards. The notch is pointed towards the top, should it be installed towards the bottom like the diff expansion boards, or is it correct the way it is printed ?
Thanks,
Shawn
