FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.7 K Views
Posts: 409
(@dim-bulb)
Reputable Member
Joined: 9 years ago

Im waiting for Scott to get me a total price so i can get one.


Reply
ChiefWarrant
Posts: 570
(@chiefwarrant)
Honorable Member
Joined: 19 years ago

Scott,

Let me first say I am a huge fan of open source and DIY builds. It is nice to see something like this gracing the pages of the forum again.

I tried checking out the BOM costs, but I get a 403 error from Digikey, what is the cost of the BOM?

Tony


Reply
DrNeutron
Posts: 2017
(@drneutron)
Noble Member
Joined: 14 years ago
ChiefWarrant wrote:Scott,

Let me first say I am a huge fan of open source and DIY builds. It is nice to see something like this gracing the pages of the forum again.

I tried checking out the BOM costs, but I get a 403 error from Digikey, what is the cost of the BOM?

Tony

When I click i I get a total for the BOM of $129.34


Reply
Posts: 629
(@dkulp)
Honorable Member
Joined: 14 years ago

The two major costs in the BOM are:
1) PocketBeagle ($27)

2) Pixel connectors (~$42)

The pixel connectors you can get a LOT cheaper on ebay if you get a bunch. For example, for $48, you can get 150 of them: https://www.ebay.com/itm/150-pcs-Screw-Terminal-Block-Connector-3-5mm-3-pin-way-Green-Pluggable-Type-New/143171473177


Reply
Posts: 87
Topic starter
(@scooter-seh)
Trusted Member
Joined: 12 years ago

To save 5 bucks you can remove the adafruit real time clock board if you plan on not using it. Some of the headers can also be omitted if you don't need them. I also made two other BOM variants, in an attempt for a "cheaper" version. The "Minimal" BOM only has the the parts required for driving the 16 pixel outputs. I removed the serial hardware, IC sockets, and all the non-essential connectors. Last time I looked that BOM was about $100. The last BOM I call the "Power Inject" BOM. This BOM is intended for people who want to use the controller to output Pixel Data only and use fuse terminals / power injection for powering the pixels. I removed all the fuse terminals and switched the pixel outputs to a cheaper 2-Pin terminal for only data and GND. It does still include serial support and some of the other headers. This BOM I think was around $80 last time I looked. I made a spreadsheet(.ods file) in the Github with all three BOM variations and the digikey part numbers. The three sheets across the bottom are the three variations. I have never built these two BOM's so there are no assembly instructions. The Link is below.

https://github.com/computergeek1507/PB_16/blob/master/PB16_Bom.ods?raw=true

Thanks,


Reply
Page 3 / 126
Share: