FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.7 K Views
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Get a wired show player and put FPP on it playing in master mode and connect it to your etherent that leads to your WiFi AP.
Put FPP running in remote mode on your PI Zero and have it drive your lights.
Add as many PI zeros as your AP can handle (usually a few hundred). Adding more PI Zero based FPP remotes does NOT add more WiFi traffic. You will NOT be sending the data across the Wifi. The master sends a single SMALL broadcast message for each frame to keep all of the remotes in sync.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

FYI: The show player really needs to be connected to the WiFi network using Ethernet.


Reply
Posts: 8
(@akhil)
Active Member
Joined: 3 years ago
MartinMueller2003 wrote:
FYI: The show player really needs to be connected to the WiFi network using Ethernet.

Thanks for the information. Thanks to Scott who made this awesome controller.


Reply
DrNeutron
Posts: 2017
(@drneutron)
Noble Member
Joined: 14 years ago

Anyone try the new PocketBeagle 2 on a PB16? Any compatibility issues?


Reply
Posts: 447
(@glycerine)
Honorable Member
Joined: 7 years ago
DrNeutron wrote:
Anyone try the new PocketBeagle 2 on a PB16? Any compatibility issues?

I had no idea there WAS a pocket Beagle 2!! Awesome! I bought several of the originals off of eBay a while back, so I'd have extras.
Anyway, sorry I can't actually answer the question. If the pinout is the same, I wouldn't foresee any problems though.


Reply
Page 124 / 126
Share: