Thank you, Scott! I'll be printing this today and will let you know how it turns out! I downloaded Tinkercad, but hadn't had enough time to work one up with younger kids at home. I'll come back later with photos!
I printed out the mounting bracket today and the receiver board mounted perfect. I used some thread rolling screws I had sitting at work to mount the receiver to the bracket. My only meanwell supplies are sitting in my main enclosure so I could not mount the board to that to verify fitment to the meanwell. Thanks again Scott! Your awsome!
Nice!
This question goes out to Scott or anyone using a BBB16 with the differential expansion board.
The differential port on the BBB16 is for Strings 17-20, when using it off the BBB16 board is the jack on the expansion board disabled for 17-20?
Or.....when the expansion board is plugged in, is the port on board the BBB16 disabled?
Just building these boards now and wondered about the overlap of 17-20.
Thanks.
DrNeutron wrote:This question goes out to Scott or anyone using a BBB16 with the differential expansion board.
The differential port on the BBB16 is for Strings 17-20, when using it off the BBB16 board is the jack on the expansion board disabled for 17-20?
Or.....when the expansion board is plugged in, is the port on board the BBB16 disabled?
Just building these boards now and wondered about the overlap of 17-20.
Thanks.
Nix this.....
I just finished board and loaded FPP.
Once configured it shows 17-20 as its own differential receiver and then a block 21-36 for the expansion.
So, you get the 4 strings on the mainboard plus the 16 strings with expansion.
Awesome!

