FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.4 K Views
Posts: 87
Topic starter
(@scooter-seh)
Trusted Member
Joined: 12 years ago

The EEPROM file is 4KB so any EEPROM 4KB or bigger should work. "24LC32A-I/P-ND" is I found doing a quick search. I haven't tested them, so order at your own risk.

Thanks,
Scott

jhauxwell wrote:Hi all,

I recently discovered this project (and just registered on the forum) and I'm really keen to build some BBB 16v2 boards in time for Christmas 2023. I can find stock of all the parts needed apart from the EEPROM - from Digikey, Mouser, or anywhere else... best lead time so far is Q3 2023. Does anyone here know of a compatible alternative that I can order from stock?

Cheers,

Joel.


Reply
Posts: 2
(@jhauxwell)
New Member
Joined: 4 years ago

Hi Scott,

Thanks for these potential alternatives - I will use DIP sockets on the board to allow for some trial and error :thup2:

Ill report back here in a little while once I have finished the build as it may be useful to others.

I can't resist a project like this!

Joel.


Reply
Posts: 78
(@jerryg)
Estimable Member
Joined: 11 years ago
jhauxwell wrote:Hi all,

I recently discovered this project (and just registered on the forum) and I'm really keen to build some BBB 16v2 boards in time for Christmas 2023. I can find stock of all the parts needed apart from the EEPROM - from Digikey, Mouser, or anywhere else... best lead time so far is Q3 2023. Does anyone here know of a compatible alternative that I can order from stock?

Cheers,

Joel.

Hey Joel, one thing to keep in mind as well, is that in the current FPP code, eeproms are limited to 32k. Scott is 100% right on the current 4k, not sure if FPP will ever need more just wanted to throw out there it could be a possibility that the eeprom currently could in theory use 32k. However if you use the sockets you can trial and error, and worse case if you go smaller and in future need more you could easily swap them in a socket.

Good Luck, Jerry G


Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

Just curious if something lie this could be used for the BBB16 boards? I'm sure antenna's could be upgraded, my main concern is if the board is
capable of running the controller?
,


Reply
Posts: 12
(@shawnd)
Active Member
Joined: 5 years ago

Good afternoon everyone. I have looked through the thread, but have not found what I was looking for. I have built a few differential receivers and was wondering if anyone was aware of a STL file for a meanwell/ differential receiver mount. I found them for the falcon, but it doesn't appear the mounting holes are in the same spot
Thanks


Reply
Page 112 / 126
Share: