DrNeutron wrote:Thanks for fixing it so quick!
My order from JLCPLC is on its way (in blue of course!)
Trying some diff expansion boards and some receivers along with the BBB16 boards (PB's were harder to find)
They (the PB) happen to be in stock at a somewhat decent price at Digikey right now: https://www.digikey.com/en/products/detail/beagleboard-by-seeed-studio/102110561/15929657
Question for @scooter_seh or anyone who knows.
I have 10 PB16's i built a few years ago and love them. I just ordered the diff expansion PCB and was going to also order the receiver out and am thinking of doing the SMD version w/ assembly to save me some headache. I have never ordered assembly/pick n' place before and have never used JCLPCB (normally use seeedstudio).
Anyway, on JCLPCB, when i upload the BOM and Position file, the site renders the board. The SMD resistors/caps are in the right place, but the rendering shows the SOIC chips rotated 90 degrees, the voltage regulator rotated 180 degrees, and the RJ45 jack is slightly offset. (See attached picture) Note: i removed most of the thru hole components as i have them already and enjoy soldering thru hole components.
I used the BOM-Receiver_Out.csv & POS-Receiver_Out.csv files on Github. Is it OK to proceed with the rendering on JCLPCB showing the parts rotated, or am i doing something wrong here? I haven't tried opening up in KiCAD yet just loaded the gerbers/bom/pos files straight to the website.
Thank you!
Here is the rendering:
woganaga wrote:Question for @scooter_seh or anyone who knows.I have 10 PB16's i built a few years ago and love them. I just ordered the diff expansion PCB and was going to also order the receiver out and am thinking of doing the SMD version w/ assembly to save me some headache. I have never ordered assembly/pick n' place before and have never used JCLPCB (normally use seeedstudio).
Anyway, on JCLPCB, when i upload the BOM and Position file, the site renders the board. The SMD resistors/caps are in the right place, but the rendering shows the SOIC chips rotated 90 degrees, the voltage regulator rotated 180 degrees, and the RJ45 jack is slightly offset. (See attached picture) Note: i removed most of the thru hole components as i have them already and enjoy soldering thru hole components.
I used the BOM-Receiver_Out.csv & POS-Receiver_Out.csv files on Github. Is it OK to proceed with the rendering on JCLPCB showing the parts rotated, or am i doing something wrong here? I haven't tried opening up in KiCAD yet just loaded the gerbers/bom/pos files straight to the website.
Thank you!
In the last 6 months or so JLC updated the position editor. Parts that needed to rotated sometimes don't anymore. I have not gone through and updated everything.
woganaga wrote:Here is the rendering:
Hi all,
I recently discovered this project (and just registered on the forum) and I'm really keen to build some BBB 16v2 boards in time for Christmas 2023. I can find stock of all the parts needed apart from the EEPROM - from Digikey, Mouser, or anywhere else... best lead time so far is Q3 2023. Does anyone here know of a compatible alternative that I can order from stock?
Cheers,
Joel.

