FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.5 K Views
Posts: 12
(@shawnd)
Active Member
Joined: 5 years ago

I am also using 33ohm resistor packs. I think it was just the length of my run past the first window that was causing the issue. I've been running like this with no issues. The other issue I am having is that my audio device keeps dropping g every time the PB16 is powered down. I have to repeat the USB cable to the small cheapo fm transmitter then it's seen again in FPP. Is there something I am missing? I am not sure why this setting will not save


Reply
Posts: 11
(@vietnamezeboi17)
Active Member
Joined: 12 years ago
Shawnd wrote:I am also using 33ohm resistor packs. I think it was just the length of my run past the first window that was causing the issue. I've been running like this with no issues. The other issue I am having is that my audio device keeps dropping g every time the PB16 is powered down. I have to repeat the USB cable to the small cheapo fm transmitter then it's seen again in FPP. Is there something I am missing? I am not sure why this setting will not save

I had similar issue I had to switch to a 3.3ohm to make it not flashing anymore. Does anyone know why?
Thanks


Reply
Posts: 11
(@vietnamezeboi17)
Active Member
Joined: 12 years ago
MikeKrebs wrote:Using WS2811, once the data hits the first pixel, it should be all about the pixels. If you change the resistance to fix a problem downstream, that would indicate you likely don't have a clean signal to the first pixel but that doesn't make total sense if the other pixels are working fine.

My issue starts at the first pixel. I've traced back to the BBB. Sorry I'm putting together the BBB16V2.1. Not sure what could cause the signal issue but if the resistor calls for 33ohms and I'm going down to 3.3 for a clean signal what do you think could cause this issue?
When using 33ohms array I have to use the Famp right after the pigtail then it works fine.
Thanks


Reply
Posts: 11
(@vietnamezeboi17)
Active Member
Joined: 12 years ago
vietnamezeboi17 wrote:My issue starts at the first pixel. I've traced back to the BBB. Sorry I'm putting together the BBB16V2.1. Not sure what could cause the signal issue but if the resistor calls for 33ohms and I'm going down to 3.3 for a clean signal what do you think could cause this issue?
When using 33ohms array I have to use the Famp right after the pigtail then it works fine.
Thanks

After playing with different settings. I've learned that if I run the pixels at 5% brightness then there's no issue using the 33 ohm array. I've hooked up the digilent and also found that signal is consistent. Could this be power to the BBB instead?


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

What Steve123 wrote. How many ports are in use, how are the pixels powered, how many pixels on each port, etc. And if the pixels are powered externally, where is the power applied? I'm looking at an image of the v2.2 version board from github, just for reference in case some of my questions don't make sense for the boards that you're using.

vietnamezeboi17: And as far as the digilent goes, which device are you using, are you using analog or digital ports, and where the signal(s) being observed?


Reply
Page 109 / 126
Share: