DMX2REN design
 
Notifications
Clear all

DMX2REN design

56 Posts
14 Users
0 Reactions
23.3 K Views
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
Macrosill wrote:Should I connect it to the CT or the transformer, which is the gnd reference for the 5v output or the dmx gnd?

The data side of DMX shouldn't have a ground.


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

The ground plane should have the best connection to the 5 volt regulators ground and the capacitors that are filtering it. This is what makes ground quiet. Think of the ground plane as a big lake and noise as waves. The bigger the lake, the less that waves will have any affect on it.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

You may want to leave a bit more gap between the ground plane and the pads because I can already hear the cussing when you create your 15th solder bridge... :rolleyes::p

I'm not sure a ground plane will have a large effect around the DC components of this but then again it can't hurt either...


Reply
Macrosill
Posts: 9739
Topic starter
(@macrosill)
Member
Joined: 19 years ago

After the suggestions above and a conversation with Wayne James I have the latest revision for review. I have made the clearance around the traces and pads .030". I have eliminated the gnd trace and connected the gnd pads via the thermal pad to filled plane option. I have also connected the regulator heat sink to the gnd plane. I also eliminated the gnd plane from the area around the 110v traces. I also added the gnd plane in the area below the rj45 jacks.

DMX2REN 3.1.4.1

Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

I use ground clearance of 20 mils if I have the room and 15 mils if I need the space. I find that typically the pad will heat up and wet before the ground place can heat up enough to even melt solder. It can happen and has but I’ve found that I can re-heat the pad and break the connection. If not then solderwick the ground and remove the excess. Of course when I’ve purposely wanted a bridge, I couldn’t and had to add wire.

I guess it depends on your soldering skills. I’ve only met one guy that couldn’t do it, but I swear that he couldn’t solder a fender on a car either.

During writing this, you’ve increased the clearance to 30 mils and it’s next to impossible bridge the solder, even you want to.

Looking at your new layout, the only question is at the mounting holes next to traces. It depends on what you’re using for standoffs but looks like a potential short if they’re metal to a metal case.


Reply
Page 6 / 12
Share: