Everyone seems to want to use small traces. Even though I usually mill my boards, the reasoning is still the same.
The fatter the traces are, the less copper you need to remove. In my case, the tools last longer and your case the etchant last longer. The cooper is basically free. Fat traces have minimal heat rise and resistance. I also try to flood my board with the ground potential. This also leaves more copper and shields noise.
I try for best and hope for less problems.
very true ernie,
i do like the idea of why run a small trace when a thicker trace will fit.
for home etching thicker traces allow more room for error. if you over etch or your resist didnt quite work then you have alot more room for error. just because you can etch traces down to .01 or what ever doesnt mean that you should try to when you dont have to.
Brian,
im sorry i though the idea was you were getting some of these boards made. If you are only expecting them to be made by you then you can ignore alot of what i said. but having said that i do like the idea of allowing for 240v mains voltages on any design shown here as one day im sure someone will copy it without knowing what they are doing for there own design.
also with regards to the trace though the RJ45. as i said, it would make it easier to etch at home if it wasnt run though the center, i didnt say it couldnt be done. the clearences are very small once you start doing things like that. but if your happy that you can do it then great.
btw as a general comment its good to see more people playing around with different designs, this was something this site was missing for a while there.
I plan on etching the boards later tonight or tomorrow. I have ordered the BOM from mouser. A couple pieces are on back order so I will have to wait to test this.
I may make some traces thicker and add a ground plane.
Thanks for all the suggestions, 2 or more heads are better than 1.
I just made some more tweaks to the pcb. I made the 110v traces .100 wide. I made all the other traces .030 wide. I added a second jumper to eliminate the trace in between the pads of the rj45. I also added a large ground plane. I made the clearance around the traces and pads .020. The ground plane is not currently connected to anything, it is just floating. Should I connect it to the CT or the transformer, which is the gnd reference for the 5v output or the dmx gnd? I think it should go to the 5v gnd but wanted to ask to be sure. I also moved the mounting holes so I could flip the board orientation in the enclosure. It made for a neater wiring layout. Let me know what you think. The ExpressPcb fila and a jpg are attached for your viewing pleasure. Thanks again for all the input.
that will etch faster
