DMX2REN design
 
Notifications
Clear all

DMX2REN design

56 Posts
14 Users
0 Reactions
23.3 K Views
Macrosill
Posts: 9739
Topic starter
(@macrosill)
Member
Joined: 19 years ago

I have moved the traces away from the 2 mounting holes in the ground plane. Again a .jpg and the ExpressPCB file is attached.

DMX2REN 3.1.4.1

Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

I’m not using ExpressPCB so I’m just going by the pic. Verify that R1 and jumpers have the right size holes, they just look smaller that the rest, no other reason.

The rest looks good as far as layout; I’m assuming the connections are right.


Reply
Macrosill
Posts: 9739
Topic starter
(@macrosill)
Member
Joined: 19 years ago

Ok, then the design is complete, maybe. Thanks again to everyone.


Reply
Macrosill
Posts: 9739
Topic starter
(@macrosill)
Member
Joined: 19 years ago

On a side note, once I etch and test the design I will be uploading the ExpressPCB file along with the pdf of the bottom copper and mirrored silkscreen for printing to the
File Library


Reply
Macrosill
Posts: 9739
Topic starter
(@macrosill)
Member
Joined: 19 years ago

The etching should begin tomorrow. Had a small toner issue.


Reply
Page 7 / 12
Share: