Wall-E
@wall-e
Trusted Member
Joined: Dec 11, 2008
Topics: 13 / Replies: 54
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

One more note... When I tried to test the left side, I left the rightside power unplugged. When I leave both power plug in for both sides, my test on...

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

Hi Everyone, I am going through the Renard SS16 Basic Setup Steps. On the left side (Channels 1-8), everything is fine, Steps 1 - 30. On the right si...

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

Hi Guy's, Answer to all the questions: Blue is in Pin 4 and Blue/White is in Pin 5 I checked the port settings and Com17 (the one assigned to the U...

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

I also just downloaded and tried that Simple Renard tester and no results. I have a USB - RS-485 T-/A using Blue wire CAT5 T+/B using Blue/White Cat 5...

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

I changed the port speed in windows from 9600 to 57600 and made sure the profile had the same. It still is not working. I have to say that I know ver...

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

I selected Com17 as it was assigned in Device manager for the USB to RS-485 and I'm still not able to get any response from channel 1....does anyone h...

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

Thanks Art.....I'm using a USB-RS-485 connection and connecting with RJ-45. What do I select for COM port?

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

Thankn you both for the quick response ! Can you you give me some clarification on the Vixen versions for the Renard SS16? I downloaded v2.1.1.0 but ...

15 years ago
Forum
Topic
Forum
Replies: 42
Views: 12319
Topic
Forum
Replies: 2
Views: 1585
Reply
RE: Heat Sink on Renard SS16

Ok, from the picture jduawa sent, you use angle aluminum and drill one side of it and place the side with holes between the 2 rows of triacs with a ma...

16 years ago
Forum
Topic
Forum
Replies: 7
Views: 3257
Reply
RE: Renard 16SS Cabling Question

Thanks everyone for the replies. Since there are a lot of different RS 485 converters out there, can someone suggest one that they had good luck with...

16 years ago
Forum
Topic
Forum
Replies: 3
Views: 2268
Topic
16 years ago
Forum
Replies: 1
Views: 1868
Page 4 / 5