Testing SS-16
 
Notifications
Clear all

Testing SS-16

2 Posts
2 Users
0 Reactions
1,869 Views
Posts: 67
Topic starter
(@wall-e)
Trusted Member
Joined: 18 years ago
[#11961]

I just completed my first SS-16 and I had some questions on the testing.

What size fuse would be good for testing? The guide says the lowest, would that be a 5 amp fuse?

I have a multimeter but do not know how to use it very well.
When testing U1, do I put the red lead on +5 and the blank lead on GND?

When testing the the other components with a wire, which pin is 1? When looking at the board, is it in the upper left corner? does the seq go 1-2-3 left to right?

Thank you !!!

Chuck


1 Reply
RavingLunatic
Posts: 1502
(@ravinglunatic)
Noble Member
Joined: 19 years ago

Both the Beginners Guide and Troubleshooting Guide have links to show you the correct locations to test.

Here is how a typical IC is numbered.

And in almost all cases, the Black lead on your DMM needs to be on a GND.


Reply
Share: