Wall-E
@wall-e
Trusted Member
Joined: Dec 11, 2008
Topics: 13 / Replies: 54
Reply
RE: Color Configuration for Talking Pumpkin

This is GREAT !! Thank you everyone for your input. Eeek, you really put some thought into your color design. Did you paint yours? I was at the Phoe...

14 years ago
Topic
Replies: 6
Views: 4759
Topic
Replies: 4
Views: 2133
Reply
RE: 8 Port Village light music animation control sequencer

More information for anyone interested..... I asked if an external timer would work with it, the response is below: External timer – The Sequencer ca...

14 years ago
Forum
Reply
RE: 30CM 8 Tube 160 LED White Mini Snowfall Meteor LED Lights

I'm also curious to the length. Can you also tell us the length between tubes?

14 years ago
Forum
Reply
RE: 8 Port Village light music animation control sequencer

Just found out more information. Each port can handle 1.2Amp Load (150 Watts) BUT it runs sequencially so no more than 1 port can run at a time. Bumm...

14 years ago
Forum
Topic
Forum
Replies: 5
Views: 2134
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

.....and I just found what I over looked......I had the JP1 jumper on. I'm using a RS485 converter. I just ran a sequence and it WORKS !!! Thanks e...

14 years ago
Forum
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

Ok, since FE comes on with the SD during a Vixen sequence, it say to: Check the Vixen settings - All these were set properly. I also confirmed that ...

14 years ago
Forum
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

I left the USB plugged in. I know it was a good connection since Comm 8 was appearing when I checked the Attached Pluggin\Renard Dimmer\Pluggin Setup...

14 years ago
Forum
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

Ugh, I re-programmed the PIC's with the Operational firmware and tried to run a sequence....and nothing. Help!

14 years ago
Forum
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

WAIT !! I unplugged the USB cable and plugged it back in and COMM 8 appeared....I wondering where in the heck it was since that's what I used last yea...

14 years ago
Forum
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

Heck no, I got all excited after the diagnostic test ran...... Ok, I went back to the guide and tried to run a seguence with the original diagnostic ...

14 years ago
Forum
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

I reflowed the solder on the ocillator and Pin2 of the PICS and now the original Renard Diagnostic firmware works. I guess this now validates the ext...

14 years ago
Forum
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

I'll do this tonoght when I get home. When you refer to "PIC pin2 ", is that on the U6 and U7 PIC's only?

14 years ago
Forum
Page 1 / 5