RL, I just tried your programming and it worked !!! I got all of then to light up in that test sequence. Ok, where do we go from here. I wasn't able...
No blinking on the board.
I just finished programming the PIC's.
Ok, I just downloaded a fresh copy of the SS16 Diagnostic firmware and it worked.....it didn't like RL's copy because of the (int OSC) in the firename...
I just tried converting the ASM from Post #15 to a Hex and i got errors. I selected 16F688 as the processor. Any ideas?
Ok, I just read the release notes and typed MPASMWIN in the windows execute line and ....wham, there it is.
Ok, I downloaded and installed the MPLAB IDE v8.87 version. How do i convert the asm to a Hex file to upload? I didn't see it include MPASMWIN.
Separate question, my 1st board stopped working last year.....and I noticed that when it's powered on and I touch 1 of the soldered pins on the Extern...
I got a Pickit2 from Sure Electronics last year and I just noticed that they did not send ANY software with it (or instructions). I downloaded a the ...
How do you run tests with built-in oscillator on the PIC's?
I swapped out my PIC's in U6 and U7 and tried it with the jumpers on JP1 and JP1/JP2 and nothing. BTW, My PIC's were programmed through a Group Buy. I...
RL, Is the internal oscillator a component or is it a part of the programming on U6, U7? I have some extra U6/U7's that I can swap out. When I get h...
Hi RL, Thank you for responding. I just put in chips in U6 and U7 and I could not get it light the lights. Does that mean it's a bad internal oscilla...
I'm still confused......On page 5 of the beginners setup guide, up to Step 47 there is no mention of connecting the board to the computer until step 5...
Hi Wayne, The test chip I have is the Beta Diagnostic Firmware. It's been a while since i used it so i can't remember if it requires a cable from the...
