Wall-E
@wall-e
Trusted Member
Joined: Dec 11, 2008
Topics: 13 / Replies: 54
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

Also, I tested the LED lights with the wire jumping and they lit up. I'm using a testing chip that I used on the last board.

14 years ago
Forum
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

Thanks for all the suggestions everyone !!!! All the wire jumping tests are now sucessful for Channels 1-16. I added the extra chips (U2, U4&5, and t...

14 years ago
Forum
Reply
RE: SS16 Board - Step 32 of Beginners Setup Guide

Yep, I have power to both sides. I wanted to use the jumper wire from one side to the other but I was concerned that it would overload the power cabl...

14 years ago
Forum
Topic
Forum
Replies: 50
Views: 12792
Topic
Replies: 1
Views: 3192
Reply
RE: Chandler/Phoenix - Renard Builders ?

fkostyun wrote:If you need help let me know - I'm in Ahwatukee Hi, I'd sure like to see what you built, it's so much easier once you get a visual ...

15 years ago
Forum
Reply
RE: Chandler/Phoenix - Renard Builders ?

Wall-E wrote:Hi Chelmuth, I have the jumper on JP3. I'm using the USB-RS485 cable. With the diagnostic chip in, shouldn't I get a response like on st...

15 years ago
Forum
Reply
RE: Chandler/Phoenix - Renard Builders ?

Hi Chelmuth, I have the jumper on JP3. I'm using the USB-RS485 cable. With the diagnostic chip in, shouldn't I get a response like on step 55? It sa...

15 years ago
Forum
Topic
Forum
Replies: 6
Views: 2682
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

Hi Guy's, Robert was very kind to test my board and the cable. I have the test chip on the board and the lights run through the test cycle but I am n...

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

Hi, If I completed steps 1-60 successfully, does that mean the board is clear of any "major" issues? Also, I was just wondering if anyone in arizona...

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

Wow, I am not having any luck.....If I could just get this 1st board operational. It's so fustrating...I'm so close.

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

Yes, I went to step 60 and could not run a sequence. The troubleshooting flow says "run diagnostic routine". I don't know where I would run that.

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

Opps, I forgot to mention....It still will not work. I connected some lights and they don't turn on.

15 years ago
Forum
Reply
RE: Just completed Renard SS16 and it won'r run diagnostic

Ok, everything tested good. I'm assumming I do not have the Diagnostic firmware on the chips. I was told there would be a sticker on it if I did. Wo...

15 years ago
Forum
Page 3 / 5