Activity
 
Notifications
Clear all
TimW
TimW
@timw
Honorable Member
Joined: Nov 22, 2007
Topics: 14 / Replies: 540
Reply
RE: Pixels forum

Isn't Putting pixels under leds like putting AC renard controllers under incandescent lighting? I can't see the distinction between the level we have...

15 years ago
Reply
RE: RGB Pixel Matrix

Jim the gamma correction on the 3001s is fantastic. Clearly superior to 2801 (at least on my 16x21 grid vs my 32x21 2801 megatree). Hard to show in pi...

15 years ago
Reply
RE: LEDTriks Fault

We are trying this

15 years ago
Forum
Reply
RE: ledtriks 1x2 will not properly display vixen 2.1.4 .led files

Did you configure the panels in vixen to be 2x1? You have to tell vixen to create 2x1 frames....

15 years ago
Forum
Reply
RE: E680/E681 group buy

I'm advised my 681 kits arrived safe and sound into Melbourne today. Thanks Mark! Tim

15 years ago
Forum
Reply
RE: Problem with Ren64xc...

AZCOMP wrote:I did try to go straight from the serial from the computer to the RJ45 also, but that didn't seem to work either. I connected DE9 pin 3 t...

15 years ago
Forum
Reply
RE: WTB: Populated LEDTriks

Excellent news !!! Now on with the show!!! Glad we could help. Must have been a bit frustrating for a while there! Tim

15 years ago
Forum
Reply
RE: RGB color test 1

Looking good.... and the soundtrack tells me where you're from without looking at your location... strangely familiar sounds!

15 years ago
Forum
Reply
RE: WTB: Populated LEDTriks

Here's the signal path for row 9. Suggest you do the same test you did before... swap the J8 and j9 plugs and see if the 'dim' row moves. If it does ...

15 years ago
Forum
Reply
RE: display problems

That does sound like a comms issue to the Triks C. First thing I would try is removing the termination resistor (R3... the 120R resistor just next to...

15 years ago
Forum
Reply
RE: WTB: Populated LEDTriks

How do you know whether its the ledtriks board (the circuit board) or the ledtriks board (the panel?). Or are you after both things (that seems needle...

15 years ago
Forum
Reply
RE: PIC PWM Capacity & New 2012 Hardware Ideas

sginut wrote:Has anyone looked into BCM (BAM) techniques to drive outputs? From what I have researched on it, it doesn't look like a candidate for TR...

15 years ago
Forum
Reply
RE: Tips for troubleshooting DC SSR

Hi TP With the tester you connect pin 1 (and/or pin 3) of the RJ45 to +5V and then ground pin 2,4,6,8 depending on what channel you are trying to t...

15 years ago
Forum
Reply
RE: Curly DCSSR problem Rated CC (Challenging Content)

But they are both .680 on your meter? 🙂 Glad you found the culprits.

15 years ago
Forum
Reply
RE: Curly DCSSR problem Rated CC (Challenging Content)

Could it be dry solder joint(s) on the board?

15 years ago
Forum
Page 3 / 37
Share: