timon
timon
@timon
Noble Member
Joined: Dec 30, 2010
Topics: 165 / Replies: 1984
Reply
RE: Yet another RS485 pixel Extender/Receiver/Power Injector

Didn't have time to get them ready for this year. I'm reworking them a bit mainly to adjust their size to stay within 5CM increments so I can have the...

13 years ago
Reply
RE: CandyPole critique please

Looks like the toppers are all gone:( Oh, how did you get all of the pixels in the holes? You must have a very small hand:wink2:

13 years ago
Forum
PVC
Reply
RE: Musical Water fountains

If you needed more than 1,000 fpm for a larger stream do you see a problem feeding two pumps into a manifold, not a Tee but more like one of these, th...

13 years ago
Forum
DMX
Reply
RE: PVC frames for mounting lights to windows?

That's interesting, who makes the trim? Depending on how thick the material is you may be able to trap the Technicolor pixels in there as well. How th...

13 years ago
Forum
PVC
Reply
RE: My main show controller enclosure

That was my plan when I make the battery backup board which also has an interface to control the FM02. The only issue driving it that way is you bypas...

13 years ago
Forum
Reply
RE: Technicolor quality?

The new PCB is a little larger and it's thicker now that is uses a 0.031 board instead of a 0.015 so that will help. The pads are now much larger so t...

13 years ago
Reply
RE: My main show controller enclosure

Sean, I was looking at the FPD and if I could get it to fit in a CG500 layered above or below my interface board that will hold the Pi. I needed to ...

13 years ago
Forum
Reply
RE: My main show controller enclosure

The vent is made by Bud Industries. They are common in the US but I don't know about down under.

13 years ago
Forum
Reply
RE: Nordic nRF51822 2.4Ghz ARM Processor

vvatts wrote:well the BL600 looks to be less than the $15 RFD22301 module (15mm x 15mm) by rfdigital that forms the core hardware of the rfduino and c...

13 years ago
Forum
Reply
RE: My main show controller enclosure

It's actually fairly quite but I will be adding ferrite beads on both the audio and antenna cables since I've found that much of the noise that can sh...

13 years ago
Forum
Reply
RE: Technicolor Pixels available in Green, White and Black

Some did, don't remember the username, and they showed the Technicolor's to be brighter. That could always change. Anyway for me there bright enough...

13 years ago
Reply
RE: Allow HLS to utilize all assigned CPU cores

Joe, I don't know for sure but if your code is multi-threaded your already heading down the right road.

13 years ago
Reply
RE: Technicolor quality?

Interesting, I'll check and make sure I didn't get that backwards. BTW, what did it look like? Could you see any visible reason why it failed?

13 years ago
Reply
RE: Nordic nRF51822 2.4Ghz ARM Processor

It can be from 5 to 15K unless you can work out a deal which I'm trying to do.

13 years ago
Forum
Reply
RE: Driving WS2811/2812 and UCS1903 LED pixels without timing constrants.

I think I looked at the same part but hadn't had time to work with it. Actually my thinking was to not use a board for the chip but just release the c...

13 years ago
Page 9 / 144