Activity
 
Notifications
Clear all
Technician
@technician
Reputable Member
Joined: Mar 23, 2015
Topics: 5 / Replies: 361
Reply
RE: E682 Power Question

covewi wrote:So I only need to send Data - from the e683 (just one wire) - and then send the 12 volts and the GRND from the external power supplies t...

11 years ago
Reply
RE: GECE with DIYLEDExpress Waterproof PS

For loading a power supply for stability with the very high dynamic load of the LED's, I find a 1 Amp load will often reduce voltage overshoot. Using...

11 years ago
Reply
RE: need clarification how to connect this little pixel driver

OK, a couple of notes. I'll start with the resistor. Normally leave it off unless it is the last DMX dimmer on a string of devices. If it is the la...

11 years ago
Reply
RE: Santa and Rudolph Caught on Camera

Many of the reindeer summer in sunny central Oregon and are on loan around the country in the winter. This is near my parents place where I grew up. ...

11 years ago
Forum
Reply
RE: Tip: How to identify 5v vs. G on pixels with same color wires

Examine the wire very closely. Many flat wires have some sort of identifier on one end wire, either the wire nomenclature or a small ridge moulded int...

11 years ago
Forum
Reply
RE: DMX Flickering part 2

To be true to the DMX spec, the Shield is not grounded at any dimmer or connected to power minus. The data feeds an isolated (opto or transformer) RS...

11 years ago
Forum
DMX
Reply
RE: GFI outlet problem

Since this is an OUTSIDE outlet, and most Digital Volt Meters have a relatively high impedance, a quick check for reversed hot/neutral, a meter probe ...

11 years ago
Reply
RE: DMX Flickering part 2

Just want to verify the last dimmer on the DMX line has a termination resistor of 120 ohms between the Data + and Data -. If you "Lift the shield fro...

11 years ago
Forum
DMX
Reply
RE: Made a dipole and it works but...

A couple of quick notes to keep you out of trouble with FCC. 1 Harmonics can play foul with devices on other bands. 2 The transmitter may be clean, b...

11 years ago
Forum
Reply
RE: Error reading MP3

On another discussion, the LAME encoder was discussed at length. The issue is it is illegal to bundle with a product such as Audacity without paying ...

11 years ago
Forum
Reply
RE: Error reading MP3

Variable bit-rate will cause this.Audacity can be used to import and export at another bit rate.

11 years ago
Forum
Reply
RE: Some strands of my Pixel Tree have a pink hue

Signal problems cause blinky flashy or no control issues, not just a slight color shift. Because Blue LED's use a higher voltage, and your string mos...

11 years ago
Reply
RE: GE Color Effects + 12v - How bad did I blow them up?

Power goes to all pixels. Good chance the string is toast. There is a possibility the first few pixels drew huge current, dropping the voltage in th...

11 years ago
Reply
RE: Installed full wave converter, blew fuses

Hit the hardware store and pick up an inexpensive DVM and do OHM checks on the diodes. We could guess, but just blowing fuses won't tell you anything...

11 years ago
Forum
Reply
RE: LOR dmx cable, which end goes where?

A crossover cable should not matter. One way placed Pin 1 to pin 4 for example. Going backwards, Pin 1 from the other end goes to Pin 4.

11 years ago
Forum
Page 5 / 25
Share: