MartinMueller2003 wrote:To me it really sounds like you have not enabled the PWM output mode. This is needed to make LEDs work properly. The 2nd issue...
kev wrote:I don't use those controllers but my guess is that they are the ones that use the MOSFET on a chip with the output limited to 1 AMP. It sou...
I know its been a while since I posted the above and I got around the problem by decreasing the number of strings on channels and the ramping/fading s...
So I was able to get 5 out of 7 bad strings up and running with new fuses. The other two keep blowing fuses so I guess there's some kind of short in ...
Thanks all. I'll check all the fuses I do have and try to get my hands on some extras.
Yeah, I get that, but I don't think I have any extras. That's why I was checking.
MartinMueller2003 wrote:pick up an espixel stick to drive the pixels. strips are 15 usd each. bullets are more resilient. Vixen 3 will do what you nee...
Thanks. I'm not too concerned with using the computer that would be controlling the show, but wouldn't be opposed to incorporating the Pi either. I'...
So, lets say I go with 8' sections and I buy 4 of these... . Where do I go from there. What do I need with regard to power supply(ies) and controll...
That sounds great! I was going to start to scale down my already small display to just the good old static lighting. Not sure why I want to delve in...
It would be cool if I could use my old sequences with the current LED strings/layout I use. I guess my first step, like I said is to decide on the ...
These sections are not going to be attached to the house per se. They are just going to be used as some accent pieces in the yard or maybe against th...
I plan on using the 4 sections primarily during the Christmas season, but may use of Halloween and 4th of July, etc, but they will not be outside the ...
