Activity
 
Notifications
Clear all
snunn
@snunn
Eminent Member
Joined: Dec 18, 2009
Topics: 4 / Replies: 31
Reply
RE: Raspberry PIxel driver.

Can anyone point me to the appropriate connector to use on a pcb for connecting the lights to. Not sure what to pick on mouser.

14 years ago
Forum
Reply
RE: Raspberry PIxel driver.

Wanted to follow up on the "slowness" I see. I can't seem to get past 2mhz since when I try to write out the bytes for a 110 strand string all the by...

14 years ago
Forum
Reply
RE: Raspberry PIxel driver.

I am still messing with the idea of multiplexing the output of the SPI. Further testing shows that from java I can drive at 2mhz, not the 4 mhz that ...

14 years ago
Forum
Topic
Forum
Replies: 2
Views: 1560
Reply
RE: Raspberry PIxel driver.

I finally have my Renard SS24 being driven by the PI using a java program. Turns out that the rs232 adapters I bought for the PI each had pins 2 & 3 ...

14 years ago
Forum
Reply
RE: Raspberry PIxel driver.

I got the ADG726 chip working to route the SPI. I also can get the PI up to 5 mhz on the SPI, after that speed the lights didn't all change as expect...

14 years ago
Forum
Reply
RE: RS232 Interface & the Renard SS24

I tested the ss24 vi the PC prior to running on the PI using custom code and vixen. I am using the same code(rxtx library) on the PC as I am on the P...

14 years ago
Forum
Reply
RE: RS232 Interface & the Renard SS24

I am using a ss24. I tried all the various jumper combinations, but no luck. I even used a rs232 break board to test the signal at the renard and it...

14 years ago
Forum
Reply
RE: RS232 Interface & the Renard SS24

Does anyone know the voltage that the renard is expecting on the tx line? I have tried both rs232 and 485. I am trying to drive the renard from a pi...

14 years ago
Forum
Topic
Forum
Replies: 10
Views: 5547
Reply
RE: Raspberry PIxel driver.

Ummm...did you look at the java code below. It is *very* easy to control the pi via java. winscp the results of a maven/ant build done via the eclip...

14 years ago
Forum
Reply
RE: Raspberry PIxel driver.

The pixel string would be about 6' from the chip. How are other pixel boards handling this?

14 years ago
Forum
Reply
RE: Raspberry PIxel driver.

This could be a single chip fix for routing the clock and spi via a single chip. However, it would require a circuit board be designed which is out o...

14 years ago
Forum
Reply
RE: Raspberry PIxel driver.

This is a rough sketch of what I have tried so far. Everywhere it says MISO it should read MOSI.

14 years ago
Forum
Reply
RE: Raspberry PIxel driver.

I have been able to "route" the clock and the data line of the SPI output to a desired output string. I am using 2 - 74HC4514's and a single 7404 inv...

14 years ago
Forum
Page 1 / 3
Share: