Does the renard SS24 RS-232 interface make use of CTS/RTS lines? Also, does any know the input voltage for the tx line?
It does not use them - there is no flow control - straight 'ol dumb RS-232. If you are talking the output lines - that is an RS-485 output.
Does anyone know the voltage that the renard is expecting on the tx line? I have tried both rs232 and 485. I am trying to drive the renard from a pi using the max3232 ese chip.
You would have to look at the specs for the ST485 or 75176 chips that they typically use - but I can't imagine things would be that different from the MAX3232 chip. Which Renard are you trying to test with? Many have a jumper to ground out the differential signal since RS-232 only supports a single signal.
I am using a ss24. I tried all the various jumper combinations, but no luck. I even used a rs232 break board to test the signal at the renard and it looks good.
