Sean Bowf
@sean-bowf
Estimable Member
Joined: Jun 4, 2007
Topics: 10 / Replies: 120
Reply
RE: 120V Rope lights on SSR

The fuse holder itself is rated at 10 amps (if I remember correctly). Not that I am endorsing the modification of the SSR boards... Personally, I wo...

19 years ago
Forum
Reply
RE: resistor question

When I was using a cheap pencil soldering iron, I would tack the TRIACs to the board by soldering one lead, then cut the leads. Then go back and sold...

19 years ago
Forum
Reply
RE: colored preview

I know this was talked about awhile back...and I think a question that came up was...what happens when you turn 2 or 3 colors on at the same time on a...

19 years ago
Reply
RE: Power draws for olsen 595 stuff (measured)

I wonder if that was associated with type of 595 we use (74HC595). It requires a certain percentage of applied voltage as a high (can't remember what...

19 years ago
Forum
Reply
RE: Power draws for olsen 595 stuff (measured)

XmasInGalt wrote:I had the same issue. What I believe he is saying is that the voltage dropped below the required 5volts so the voltage to each opto ...

19 years ago
Forum
Reply
RE: Potential Renard64 Changes

Phil, why is it necessary to take the negative part of the AC sine wave to ground?? Not trying to say not to do it...trying to understand why it is d...

19 years ago
Forum
Reply
RE: Potential Renard64 Changes

Hard to see the pic well enough to follow out all the traces (and I am in front of a 22 inch monitor). I guess I need to stick around more so I can k...

19 years ago
Forum
Reply
RE: Power draws for olsen 595 stuff (measured)

Joe, what is the value of the SIPs on your controller board and the opto input resistor in your SSR boards?? Sean

19 years ago
Forum
Reply
RE: price question

Aurbo99 wrote:I am running a MAX 100 cnt string of mini lights per channel, the fuse protects 4 channels per SSROZ, would I be safe to use this 4amp t...

19 years ago
Forum
Reply
RE: Parts Kits Interest (2008)

Greg in Canby wrote: Mine say SSR v2.4, whats the difference? Greg WJohn had come to me to help proof his layout for an SSR PCB he was going to sel...

19 years ago
Forum
Reply
RE: Potential Renard64 Changes

MonteryJack wrote:I like the Transformer onboard for power. MontereyJack, I don't think the transformer is on board. It is the only component that...

19 years ago
Forum
Reply
RE: To dim or not to dim

slug wrote:So I can use the ssr design depicted here as the remote ssr? I've already got all the parts except for the pcb, which I can etch. Yes....

19 years ago
Reply
RE: Help with Off Subject PCB

Pin 4 of U1 and U2 are only connected together, not to anything else. According to the schematic on the web, it is supposed to be a reset, only tied ...

19 years ago
Forum
Reply
RE: Input please on my revised SSR board

Re: I think I got it.. barrynash17 wrote: How do you solder the top trace under the cat5 jack? Barry, that is the COOP board layout...it is a manuf...

19 years ago
Forum
Reply
RE: Soldering Irons

One of the things I love about my HAKKO 936, is that I can plug it in, turn it on, and in 30 seconds, be melting solder with it. It heats up that fas...

19 years ago
Page 1 / 9