resistor question
 
Notifications
Clear all

resistor question

17 Posts
11 Users
0 Reactions
6,490 Views
Posts: 89
Topic starter
(@rickeys)
Estimable Member
Joined: 19 years ago
[#2161]

I'm new here and don't have a lot of circuit/electronics knowledge. But I can solder and am building a grinch and 16 SSR's. My question is does it matter which way (direction) a resistor is soldered on a pcb?
Thanks
Rick


16 Replies
Posts: 93
(@deast)
Estimable Member
Joined: 19 years ago

The resistors we are using are non-directional.


Reply
Posts: 89
Topic starter
(@rickeys)
Estimable Member
Joined: 19 years ago

Thanks
Rick


Reply
kmc123
Posts: 824
(@kmc123)
Prominent Member
Joined: 19 years ago

Just as a note - NO resistors have polarity...


Reply
Posts: 89
Topic starter
(@rickeys)
Estimable Member
Joined: 19 years ago

Thanks,
Another question, on triacs is it okay to cut the leads shorter and then solder them on the pcb? I'm assuming that it makes no difference on the length of the leads. Again sorry for these simple questions but I don't want to screw something up and waste time and money.
Thanks
Rick


Reply
dnesci
Posts: 563
(@dnesci)
Honorable Member
Joined: 19 years ago

I believe most people would cut the leads after they are soldered to the board. This will assure that the leads are long enough to make a good connection. The length is not the issue, the connection is the important part.


Reply
kmc123
Posts: 824
(@kmc123)
Prominent Member
Joined: 19 years ago

Agreed - And the triacs DO have polarity - Be sure to put them in the correct way.


Reply
Posts: 130
(@sean-bowf)
Estimable Member
Joined: 19 years ago

When I was using a cheap pencil soldering iron, I would tack the TRIACs to the board by soldering one lead, then cut the leads. Then go back and solder the rest (and reheat the first one I did last). The long leads seemed to take the heat out of the iron...so cutting them shorter allowed me to solder them with the cheap soldering iron.

Sean


Reply
Posts: 65
(@acewingman)
Trusted Member
Joined: 19 years ago

If you cut the leads before soldering then more of the heat will get to the component since the lead acts as a small heatsink and draws some of the heat away from the component.


Reply
Posts: 89
Topic starter
(@rickeys)
Estimable Member
Joined: 19 years ago

hopefully I put the triacs in the correct way, I looked at this picture http://doityourselfchristmas.com/wiki/index.php?title=SSR
and put them in as shown.

Thanks
Rick


Reply
Page 1 / 2
Share: