sdkraemer
@sdkraemer
Trusted Member
Joined: Aug 20, 2018
Topics: 11 / Replies: 22
Topic
Replies: 2
Views: 8365
Topic
Forum
Replies: 1
Views: 5282
Reply
RE: The ChromaCane by Boscoyo Studio

Xlights noob here. I saw it was mentioned in this thread that bar effect and spirals work well. I applied both and they look OK on Chromacane 48s. Doe...

8 years ago
Reply
RE: Chromacane 99 Odd Sequence

Probably a related question. We were debating which side is data in on his pixels. My pixels have the chip on the data out side. Is this always the ca...

8 years ago
Forum
Reply
RE: Chromacane 99 Odd Sequence

uncledan wrote:If you used the model in Xlights wiring view is from the back of the cane. You can flip the model horizontally under model data depend...

8 years ago
Forum
Topic
Forum
Replies: 3
Views: 2373
Reply
RE: Multiple Routers Setup Issue?

Actually, so I deleted that odd persistent route 0.0.0.0 and I seemed to fix the problem. Sent from my ONEPLUS A6003 using Tapatalk

8 years ago
Topic
Replies: 2
Views: 1420
Reply
RE: Would 12V pixels work on 5V power supply?

TazChaLet wrote:can you take a good close picture of both the 12v and 5v pixels maybe we can see a difference that could help decide The first image i...

8 years ago
Reply
RE: Would 12V pixels work on 5V power supply?

jchuchla wrote:Not the chip, the pcb. Look at where the power wires connect and see if they’re labeled with a voltage. Sent from my iPhone using Ta...

8 years ago
Reply
RE: Would 12V pixels work on 5V power supply?

I'm hoping they stuck it in the wrong bag or just mislabeled it.

8 years ago
Reply
RE: Would 12V pixels work on 5V power supply?

The two strands were in a static shield bag with a white label sticker that says "G26 12V 2811". I tried looking on the chip. Without a magnifying gla...

8 years ago
Topic
Reply
RE: F4V3 Mounting Plate

Thanks for the ideas! Jdeation looks interesting. I created a mounting plate in a CG-1500 using plexiglass. I'm not sure if plexiglass was the right c...

8 years ago
Reply
RE: Soldering Pigtails

rstehle wrote:IMO the twist is a waste of time. I have never had a shrink tubed lap joint fail, and I have done thousands of them. Anyone know the ...

8 years ago
Page 1 / 3