Chromacane 99 Odd S...
 
Notifications
Clear all

Chromacane 99 Odd Sequence

4 Posts
2 Users
0 Reactions
2,374 Views
Posts: 33
Topic starter
(@sdkraemer)
Trusted Member
Joined: 8 years ago
[#49850]

I've setup a chromacane 48 successfully before. Now I'm trying to get a chromacane 99 setup. We verified it was wired correctly. I applied a vertical bar effect with white, red and blue. It looks like it's going through the string sequentially. Anyone have any ideas what would be going on?
Here's the video: https://drive.google.com/file/d/1VQ4bdRyYauIO4JtTYV34ce2g2rMLuEW1/view?usp=drivesdk

Sent from my ONEPLUS A6003 using Tapatalk


3 Replies
Posts: 486
(@uncledan)
Honorable Member
Joined: 11 years ago

If you used the model in Xlights wiring view is from the back of the cane. You can flip the model horizontally under model data depending if its facing left or right.


Reply
Posts: 33
Topic starter
(@sdkraemer)
Trusted Member
Joined: 8 years ago
uncledan wrote:If you used the model in Xlights wiring view is from the back of the cane. You can flip the model horizontally under model data depending if its facing left or right.

Yup I flipped it to the correct orientation and made sure we looked at the back side while wiring.

Sent from my ONEPLUS A6003 using Tapatalk


Reply
Posts: 33
Topic starter
(@sdkraemer)
Trusted Member
Joined: 8 years ago

Probably a related question. We were debating which side is data in on his pixels. My pixels have the chip on the data out side. Is this always the case with ws2811 pixels?

His pixels also differed from mine where my arrow points up, where his points down. Does the orientation of the arrow matter, or is it just an indication of the data in side?

Sent from my ONEPLUS A6003 using Tapatalk


Reply
Share: