Have not tried bending the tubing yet. Was thinking paint stripper hot air gun and tie down strap to assist, but have not decided on size of arch or ...
This is a link to a test video using a ws2811 3-LED pixel strip in a 40mm tube from screwfix Its just a quick video showing the LEDs showing throu...
Damian, I'm using ws2811 tape with 3-leds per pixel 12V but this is because I have plenty of these in my box. Driving them from DMX. I have not s...
MikeF that works a treat thanks for the tip. The screwfix FLOPLAST PUSH-FIT PIPE WHITE 40MM X 3M is great. Damian the pipe was manufactured in Ire...
Its DMX to what every you put on the other side. relay,led, servo, stepper motor. The shield is just a DMX input or DMX output from an arduino.
This code is quite good for DMX I have not used it in years but has people working on it. If you are switching mains then I would suggest an isolat...
Here is another one you'll like in here you can find schematic and PCB layout. Again I have not used it and cannot tell how got it is.
This is an example of what you need, note I have not tested this and cannot verify it but it looks ok:
2 more opto-couplers in the reverse direction driving the RS-485 driver, one for direction change TX/RX and one for serial transmit. The main problem...
So attached is the schematic of a DMX/RDM sniffer I created last year. Its not a full isolated RS-485 physical interface but add 2 more opto-couplers...
Are worth a look.
If you search ebay for "enttec dmx" and sort by price then you will find a micro-controller based DMX controller. There are cheaper alternatives bu...
All, I have just found and built an ESPixel and it is great works very well for my simple test. Anyway is there likely to be a group buy of the po...
