Activity
 
Notifications
Clear all
rodb
@rodb
Eminent Member
Joined: Nov 2, 2010
Topics: 6 / Replies: 28
Reply
RE: Are there any diy e1.31 bridges?

I was thinking of doing a 4 to 8 port E131 bridge based on this ST development board STMICROELECTRONICS NUCLEO-F767ZI DEV BOARD, NUCLEO-32 MCU The ...

10 years ago
Reply
RE: login timeout very short

That solves the problem thanks.

10 years ago
Topic
Replies: 2
Views: 4410
Reply
RE: Sending WS2811 signal over RS-422 and reconverting remotely?

All, So I decided to add reverse voltage and over voltage protection circuits and then choose a switching regulator that would operate between 6V and...

10 years ago
Reply
RE: Sending WS2811 signal over RS-422 and reconverting remotely?

Sorry about this I'm not trying to be cleaver or smart but found this on e-bay: That's 100 Pcs or MAX485 for £3.30 total. That's less than 0.04p pe...

10 years ago
Reply
RE: Sending WS2811 signal over RS-422 and reconverting remotely?

Thank you All, That has given me a lot to think about. I have ordered some of the e-bay RS-485 boards to test out. But for me the challenge is in th...

10 years ago
Reply
RE: Enttec USB Pro protocol

happymaurice wrote:I built a converter using my dev board and I am sure that I completely comply with this protocol, but I still can not get connecte...

13 years ago
Forum
DMX
Reply
RE: Driving WS2811/2812 and UCS1903 LED pixels without timing constrants.

Robert, Attached is the circuit in PDF format it is very simple I have not yet considered RF but starting to thinking about it. Anyway good luck and...

13 years ago
Reply
RE: Driving WS2811/2812 and UCS1903 LED pixels without timing constrants.

Robert, For instance like this one a 4 channel PWM DMX conroller based on te LPC812 I have not finished the design I'm still thinkinng about HW and S...

13 years ago
Reply
RE: Driving WS2811/2812 and UCS1903 LED pixels without timing constrants.

Robert, I have played with these devices and they are great. I cannot believe now much I can squeeze into such a small amount of code. On one of th...

13 years ago
Reply
RE: Driving WS2811/2812 and UCS1903 LED pixels without timing constrants.

robertk wrote:It looks like someone already code this up using the SPI + SCT. The SCT creates the duty cycle needed by the 2811/2812 and the SPI stre...

13 years ago
Reply
RE: Driving WS2811/2812 and UCS1903 LED pixels without timing constrants.

My current thinking is SPI communications and in 2 modes: In HW mode I would expect SPI to run at 800KHz this would allow for an unlimited number of ...

13 years ago
Reply
RE: Driving WS2811/2812 and UCS1903 LED pixels without timing constrants.

This is what I'm thinking, a 1-inch square PCB. I have not fully sorted the sw out but I'm working on it.

13 years ago
Page 2 / 3
Share: