sallz0r wrote:Not sure why the display preview data isn't being persisted, though..... after you close the setup for it, and reopen it, is everything ...
If you're looking for LED's CDI will be doing a pre-sale soon.
ppohlman wrote:I finally had some time to play around with Vixen 3.0. Great work! It will definitely take a little while getting use to the new way ...
Looks great! But I think you have a bulb out on the 5th string from the right, near the bottom. :wink2: BTW, how is your star attached?
One thing that may help you in figuring how to space your strings is to realize that your bottom spacing will be the same as if you were making a regu...
Applying it to the group worked fine for me. Not to be funny but are you sure that your preview setup has a dot for each of the channels that are in ...
I have some of the unsealed strings as well. I haven't used them yet due to this issue. I've read that you can put some dielectric grease on the con...
tronman wrote:KC, In response to your question, In the Channel and Group Configurations window on the right, in the 'operations' frame is where nodes ...
I'd like to see the preview editor make use of the channel groups and have built in elements that you could associate them to. So that my 12 channel ...
Didn't notice that. I was trying to do it in the sequence editor. I just tried it your way and it works great. Thanks sallz0r! Oh, and I also foun...
OMG! You guys must be geniuses. Either that or I am. 😉 So I'm a total newb when it comes to sequencing. Never touched the stuff. I just did a...
OK, first minor issue. I added a Renard controller then increased the channels to 24 and clicked update. That worked fine. I then renamed it to Ren...
Downloading now.... Thanks KC and the Sunshine Band for all your hard work!
That would be one way to do it but it sounds like quite a bit of work. An easier way would be to use side view led strips like these. I haven't trie...
Not to hijack this thread but whatever happened to Prancer? It doesn't look like its actively being developed.
