Activity
 
Notifications
Clear all
PCPackrat
@pcpackrat
Trusted Member
Joined: Nov 28, 2015
Topics: 7 / Replies: 43
Reply
RE: GECE on espixel controller slow by 400+ miliseconds

Re: GETS on espixel controller slow by 400+ miliseconds Ok I managed to get it timed by reducing the pixel count on the esp controller. If I go any h...

9 years ago
Forum
Reply
RE: ESPixel GECE Info Thread

I posted this under vixen but just in case, I'll do it here. I'm noticing a 400ms delay from when vixen tells the lights to do something and they res...

9 years ago
Reply
RE: GECE on espixel controller slow by 400+ miliseconds

Got my faces connected. They are timed perfectly. I hope I can get the GECE figured out.

9 years ago
Forum
Topic
Forum
Replies: 5
Views: 2236
Reply
RE: Unexpected error while drawing the grid

I figured out what caused it. I installed some virtual sound drivers for my sdr and it seems to freak out vixen. I deleted them out of device manger a...

9 years ago
Reply
RE: ESPixel GECE Info Thread

duramadmax wrote:ANy special instructions and links to firmware version? I never could get 2.0 to load.... The firmware is here: Read through the...

9 years ago
Reply
RE: RenardESP Information Thread

I think as of 3.0 the data pin is now on GPIO2 of the ESP6288. I haven't verified this yet but I will test it out this weekend. I suppose this leave...

9 years ago
Forum
Reply
RE: RenardESP Information Thread

I loaded up 3.0 and no serial data now other than the standard logging messages. Is serial out of the ESP8266 now coming from GPIO2?

9 years ago
Forum
Reply
RE: ESPixel GECE Info Thread

I loaded 3.0-rc3 last night after many attempts at not reading things thoroughly and finally got it. The web interface is really pretty. I will conn...

9 years ago
Reply
RE: Espixel by Bill Porter

Oohh! Version 3 is in RC. I never got to run V2 due to having the 512K esp8266.

9 years ago
Topic
Replies: 1
Views: 1066
Reply
RE: ESPixel GECE Info Thread

Not sure if I should start a new thread or not. I have noticed that if the wifi access point goes down, the espixel don't reconnect until you power c...

10 years ago
Reply
RE: ESPixel GECE Info Thread

OK I gave up on 2.0 and went back to v1.4. I had all mine flashed but I have one that is swapping red and blue. So I reflashed it and it's still doi...

10 years ago
Reply
RE: ESPixel GECE Info Thread

I cant seem to get the new ESPixelStick to compile. I'm getting the following error: Arduino: 1.6.5 (Windows 8.1), Board: "Generic ESP8266 Module, S...

10 years ago
Page 2 / 4
Share: