I'm inspired by this thread so I thought I'd add my humble thoughts. Gosh, it's hard to know where to start. I've been decorating since I was so yo...
I’m in too!
I like Molex, but not for outdoor stuff. It looks like he's using a single Molex for most of the channels. So why not just use the standard water ti...
The scale prototype looks pretty good! On the model, maybe taper in the threads a bit at the beginning? I've had to increase my min layer time in spo...
Hey dudes! Thanks man! 🙂
I think Page-12 of the manual is very helpful when having communication difficulty. You can either have it tell you what address it's using or you ca...
(EDIT: I see the power buttons are lit up) So yes, in the manual you can find the factory reset option. It can also tell you what IP address it's ...
Sounds like a fun project!! I run three 20A circuits for my show. During new construction I put two 20a circuits with some outlets on under the eves...
I wish someone would say this for me. "Hey, he's close to his vacation, probably has short-timer's, plan to reach out later on". :biggrin2:
I ran about 300 channels for a couple years before jumping up to over 5K with a pixel tree. I had two dongles and tried various types and styles. So...
Terry, stop peeing on your controllers. :pragnie: Hee hee hee hee Hi buddy!. My Wireframe Bethlehem star looks amazing!. Solid as a rock 18' up t...
Nice tip on the wizard. I always just copy the whole profile directory over and it works great.
I just stumbled across the answer. I'm using an older version of IE and even with "Compatability View" turned on it had no effect. I tried Chrome an...
Ah, the beats and bars tool is what I am after, I didn't see it in the Mark Manager so was confused. Works great! Thank you-
