mikekowdley
@mikekowdley
Eminent Member
Joined: Nov 27, 2010
Topics: 3 / Replies: 12
Reply
RE: Whew! Long troubleshooting averted!

Excellent, thanks for the information. I expect to try RS-485 later in the year with two 16SS's, so at that time I'll know to install the JP2 jumper t...

16 years ago
Forum
Reply
RE: Whew! Long troubleshooting averted!

budude wrote:JP2 – 120 ohm termination resistor enable. Normally a shunt will be installed on JP2. Remove the shunt if you are experiencing problems w...

16 years ago
Forum
Reply
16 years ago
Forum
Reply
RE: building the squid for my first controller

materdaddy, kychristmas, ernie, and griffixdc - thanks! this is just the sort of ideas i was looking for.

16 years ago
Reply
RE: building the squid for my first controller

Thanks! That info pointed me in the right direction for some wikipedia reading on the topic too. Any other thoughts about plugging store-bought outd...

16 years ago
Topic
Replies: 14
Views: 5825
Reply
RE: trouble programming my PIC

Yep, that's all it took. Moving forward again, thanks!

16 years ago
Forum
Reply
RE: trouble programming my PIC

I don't have any jumpers installed at all. I read the document that came with the board (ICSPAdapters-v1.2.pdf), but I wasn't sure what to make of it...

16 years ago
Forum
Topic
Forum
Replies: 4
Views: 4313
Reply
RE: Haste makes Waste

thanks for the information... i suspected it would be okay reversed, but i pulled it out and ruined it anyway, so i'll just order a new one. going to...

16 years ago
Reply
RE: Haste makes Waste

Tallahassee Dreamer wrote:this time when placing 6 pin chips I paid attention to direction they went in went back to old board and realized that some ...

16 years ago
Reply
RE: Quest for enclosures is over

I purchased a Keptel CG-1000 from , this week, it was $20 + $10 shipping. Should arrive this week. Does that fit the bill?

16 years ago
Forum
Reply
RE: question about getting started

Fantastic, thank you! I searched for both "tool" and "tools" on the wiki but neither revealed this page. I used the word gun because it would be awe...

16 years ago
Reply
RE: question about getting started

Great, thanks for the points in the right direction. I found the CG-1000 via google at , I'll have to do a little more research and then see if I ca...

16 years ago
Topic
Replies: 4
Views: 2786