Activity
 
Notifications
Clear all
marx1
@marx1
Reputable Member
Joined: Aug 4, 2008
Topics: 40 / Replies: 169
Reply
RE: Those of you using solely esp (wifi) controllers...

T.D.Sutton wrote:After two years of running Pixelsticks as Pixel controllers, this year has been a total disaster for me. From my experience, if you...

8 years ago
Reply
RE: Running pixels at automobile voltage?

davros wrote:The automotive environment is not electronics friendly, DO NOT power directly off the supply. Load dumps can generate IIRC 80Vish spikes ...

8 years ago
Reply
RE: Running pixels at automobile voltage?

I've ran 12v dumb pixels, 2811's strips from ray wu fine from 12v automobile systems. Most of the time they are designed for up to 14v; it just dissip...

8 years ago
Reply
RE: p10 duplication problem

How are your panels physically cabled? based on your config you're doing top panel to the bottom panel in four columns. I would do two outputs, one fo...

8 years ago
Reply
RE: Pixels on oak tree's

I wrap the trunk of my fruitless mulberry with a 100pixel net from ray wu: it works well. In xlights I sequence it as a matrix.

8 years ago
Reply
RE: Soldering Pigtails

mrGrumpy wrote:Cold Solder joints Using lap joints doesn't cause cold solder joints. Poor soldering technique, not using flux, or using 60/40 solder...

8 years ago
Topic
Replies: 1
Views: 3
Reply
RE: e682 - powering board from 6V

You can always get a buck/boost converter that outputs 5v and run the board off that via the aux power connector...

8 years ago
Reply
RE: FFP and time update issues

so it's your DNS server settings. on your first post you have a picture. On the very bottom of it, it shows DNS settings. Change the first entry to be...

8 years ago
Reply
RE: FFP and time update issues

gassy wrote: So that's odd, it's countering what your previous post about the ntpq -p (basically the same command) outputted. ntpq askes the NTP ser...

8 years ago
Reply
RE: FFP and time update issues

From ssh run this command: ntpq then type in: peers. Look for a * in the far left side next to the remote this means it's synced to that server. h...

8 years ago
Reply
RE: ESPixelStick Lag

I had similar issues. I was able to fix it with three changes: -Updated to the October 20th build of 3.1 -Dumped the UBNT Loco M2. I had coverage iss...

8 years ago
Topic
Replies: 1
Views: 5
Reply
RE: Got a question regarding WS811 reels from DIYLEDExpress...

I know some pixels are sensitive to the data drive level. The E6804 drove it at 3.3v, but removing J9 bumped it to 4v. I mention this because I have...

8 years ago
Reply
RE: What is a current cheapish transmitter that supports RDS?

I user a non-rds version version of the EDM-LCD transmitter going on 5 years now. I run low power mode and get significantly more than 200' with good ...

8 years ago
Forum
Page 1 / 14
Share: