As you will see from the attached video - i have a 4x2 p10 setup - and it is duplicating the display - i have attached my setup pics for BBB/FPP - does anyone have a suggestion?
I am using xlights to test the display atm.
How are your panels physically cabled? based on your config you're doing top panel to the bottom panel in four columns. I would do two outputs, one for each row; and cascade each panel sideways, not vertically.
Yes, post a picture of your ribbon cable layout.
Also - do not Enable E1.31 - LED panel is the output and does not use E1.31.
mrGrumpy wrote:Yes, post a picture of your ribbon cable layout.Also - do not Enable E1.31 - LED panel is the output and does not use E1.31.
Hi - yes maybe that is the issue - i am in fact wired to putput 1 and 2 - and then they ribbon across so 4 on output 1 and 4 on out put 2
How should i have it set up then?




