p10 duplication pro...
 
Notifications
Clear all

p10 duplication problem

7 Posts
4 Users
0 Reactions
1,564 Views
Posts: 35
Topic starter
(@ausrod4)
Trusted Member
Joined: 11 years ago
marx1 wrote:How are your panels physically cabled? based on your config you're doing top panel to the bottom panel in four columns. I would do two outputs, one for each row; and cascade each panel sideways, not vertically.

That is definiutely how i have it - when i change the layout of the p10s to have 01 in 1 row and p 1 to 4 (repeated below) i am still getting this weird duplication of pixels

ege when i test an ip range in xlights - two colums light up on panel 2 and 4 - exactly the same - any ideas?


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

what about arrows the arrow should match the arrows on the back of your panels, O is output so on board you should have label that tells what output you are using say output 1 and output 2 lets say top row is in output 1 so all the top numbers would be o-1 and then p-1 p-2 p-3 p-4, the bottom row say it is in output 2 so it would be o-2 on all of them and p-1 p-2 p-3 p-4, this starts at the first panels connect in the string of panels


Reply
Page 2 / 2
Share: