Thanks, guys! I did rebuild the ground plane legs with 10AWG so they'd stand out properly and it sounds fantastic.
Just so the info is here, as well... Quote from Phil Massey's response on LOR Forum: This method also works and saves having to create all those txt ...
makes PCBs that will allow anyone to solder surface mount components with any electronics soldering iron. The Solder Resist Layer is super thick and t...
That is an awesome show! Guess whose wife wants a mega tree and arches next year! Just like going to my buddy's reef tank, sometimes she just needs ...
I don't simulate; I build them. 🙂 However, a mortar (4" pipe) with a strobe at the bottom and a speaker behind it for the FOOMP would be a nice tou...
Just had a thought since I've been in antenna land all day... These were used with a powered GPS antenna (receive). I have now way of knowing if they...
I immediately thought of that J Pole site since I had used it previously. Cost being a factor this year, I figured I could make this for about $10. I ...
Eh... not great, but it mostly works. Whiny and not much signal to noise even when about 20' away from the car. I'll go looking for my ferrite bead co...
I'm making the 1/4 Wave Vertical, not the dipole. Turns out I bent one loop just a little too short and ended up at 58.75" instead of 58.9". Testing ...
Just to confirm, for 95.3MHz, online calculators say 29.5" for the radiator and 58.9" for the halfwave ground plane. Working through the equation in t...
Are you all on Christmaslightfinder.com? If not, post or PM your address and I will add it to the route we will drive this weekend. Going to have to ...
