Hey Bob, you wouldn't happen to have your code posted somewhere I can take a loot at would you?
it looks as though you have traces (LEDs / Switch) below the antenna of the ESP. You may notice issues as a result. The antenna should stick over th...
45 Watt 6th Generation Hobby laser cutter from Full Spectrum Laser. After putting them out I am very dissapointed... I was absolutely clueless to the...
I would consider a Wiper Blade Motor. Lower RPM and Higher Torque.
Your work area is WAY too CLEAN! Are you positive you meant to say three weeks? 😉 I crammed it into 6 weeks and my workshop is still an absolute dis...
Just a few days ago I placed an order for one of these. I am hoping it will replace the huge AV Receiver I currently have tucked inside my controller...
Maybe also take the opportunity to invite them to a show and tell for your setup.
It's cold out... So I decided that I would make a little truss mount so that when I do brave the cold and go out and mount mine under the eaves it won...
At work I make thousands of cables using a really good pair of ratchetting crimpers to install the male ends on patch cords. But we don't ussually st...
I have a couple of those lasers off ebay as well, but I haven't put them out yet... 🙁 I think I'm almost out of time eh? LOL They aren't meant for o...
I've got hundreds of hours into my display, but you have to start some where! I'm not sure if shipping would be possible for the weekend... 😉 But ...
+1 here
Thanks guys! I certasinly appreciate the compliments. I think my wife's smile was bigger than the kids, and she hasn't seen the Magic Trees yet becua...
