ESP8266 12E Pixel C...
 
Notifications
Clear all

ESP8266 12E Pixel Controller

3 Posts
2 Users
0 Reactions
2,287 Views
Posts: 35
Topic starter
(@dvjcodec)
Trusted Member
Joined: 11 years ago
[#41131]

I want to show my last project - ESP8266 12E Pixel Node.
This small controller (50x22mm) work with great ESPixelStick firmware.
Controller have:
- two LEDs: Power and Signal Out
- program switch
- two voltage regulators (can be drive with 5 and 6-12V power supply)
- 74HC245 on signal Out for prop 5V signal level
- ESP8266 12E module
- 3-pin port for FT232 connect (direct Arduino program)
How to set-up ESPixelStick firmware with Jinx! you will find on my Google+ channel --> https://plus.google.com/+dvjcodec/posts/AkwKRNdnSKW
Tommorow I will get 1st boards, so REAL photos will be uploaded soon 🙂

ESP12 Pixel node 1
ESP12 Pixel node 2

2 Replies
Posts: 35
(@krusty)
Eminent Member
Joined: 15 years ago

it looks as though you have traces (LEDs / Switch) below the antenna of the ESP. You may notice issues as a result. The antenna should stick over the board or you should not have any traces or ground plane under the antenna and it should be at the edge of the board as you have already done.


Reply
Posts: 35
Topic starter
(@dvjcodec)
Trusted Member
Joined: 11 years ago

Thnx. I will check it and make fixes if needed. When make connections suggest this product
http://www.aliexpress.com/item/ESP8266-serial-WIFI-Witty-cloud-Development-Board-ESP-12F-module-MINI-nodemcu/32569199462.html
This node work prop (i tested).


Reply
Share: