timon wrote:By the way just how high and at what size can you drive a stream of water with that pump? I can get a 1/4in stream about 9ft in the air....
timon wrote:What about the controller that drives the pumps, is that Commercial, home built or open source? Its a home built controller that uses an...
timon wrote:How do you talk to the controller, DMX? Is it your own design? Yes I use DMX and I use A open source lighting control program called "DM...
covewi wrote:Water fountains are my main interest too and spend time learning light and power control from this forum.... Check out this guys work......
LightUp wrote:Thanks for sharing your design. I'll have visit some of our local marinas to see if these bilge pumps are cheap enough to experiment wit...
LightUp wrote:Do you use one pump for each nozzle?, Or one pump for each fountain but a manifold for the nozzles? Do you control the water stream via ...
Here is one I did last year. I used boat bilge pumps and an FPGA based controller.
You sad you had an FTDI board? Is that a USB to Serial converter? Does your Mega2560 have an FTDI chip for it's USB to Serial converter? If so. Then y...
I don't know if you know how to program an ardunio but you could use ws2811 pixel leds and use the NeoPixel driver running on an ardunio but you would...
Dont1982 wrote:Does anyone know where i can get a 4 channel dimming module for the arduino uno????? My relays wont do dimming and I think my christmas...
jchuchla wrote:Oh I don't know that I agree. I'm also in the pro lighting world and I use sACN a good deal. ArtNet has been around longer so it's for ...
jchuchla wrote:Not at the moment. There is no ArtNet support in vixen 3 (yet) it's not that it's not possible, but there is such low demand that it ...
For those of you who are interested. If you get a USB to RS485 converter that uses the FTDI USB to serial chip it. You can use it as a ENTTEC OPEN-DMX...
budude wrote:Can you elaborate a bit more? Is this general uC or a specialized chip? Can it be reflashed for possible new features or bug fixes? The...
The chip I am using is a Microchip 16F873 uController. It converts 8bit DMX channels to 4bitx3 GECE commands. The GECE commands are transmitted contin...
