Activity
 
Notifications
Clear all
johnpdo
johnpdo
@johnpdo
Estimable Member
Joined: Jul 17, 2011
Topics: 19 / Replies: 83
Reply
RE: How to connect my Renards to FPP or KULP k8-B

OK, after much back and forth with the KULP, the USB to RS485 dongle, and trying a couple of different USB hubs, I finally got it all to work. When I ...

2 years ago
Reply
RE: How to connect my Renards to FPP or KULP k8-B

I'm making the change to xlights, due to the pixel nodes. My understanding is the serial port on the KULP K8-B is one of the RJ45 sockets labeled 13-...

2 years ago
Topic
Topic
Replies: 2
Views: 1392
Reply
10 years ago
Reply
RE: Help! What is going on with my controllers?

And the answer is......re-flash the xbees. I first tried just straight cat5, and as above, it didn't work well cause I rushed it. Then the trip to ...

11 years ago
Forum
Reply
RE: Fog Machine Trigger

I controlled it with vixen wirelessly to the miniren 4xB . Vixen also ran the program for my organ playing skeleton Quartet. It was a lot of fun! The ...

11 years ago
Reply
RE: Help! What is going on with my controllers?

oh, right. It's been awhile since my show ran flawless for several years, until late last year. Set the com port to the same as the Renard plugin. ...

11 years ago
Forum
Reply
RE: Fog Machine Trigger

I did it here: Used a miniren 4xb a 110 coil dpdt at amazon HH52P 110/120VAC Coil DPDT 8 Pins Electromagnetic Power Relay w DYF08A Base worked ...

11 years ago
Reply
RE: Help! What is going on with my controllers?

Reflash the chips, reset the xbees, try with hardwire only. Sounds like a good plan. When I run xctu, the chips come up 57,600, 8 Mark 1 The W...

11 years ago
Forum
Reply
RE: Help! What is going on with my controllers?

All the channels work properly if I go through the channel test slowly, or if I run a 1 second sequence on each channel. If I zip sequentially thro...

11 years ago
Forum
Topic
Forum
Replies: 9
Views: 3206
Reply
RE: FS: REN48LSD - Set of 4 unassembled complete BOM

Sent a PM, but not sure if it went. I'll take 2 if still available. I'll send the paypal as soon as I know Thanks, Doc

11 years ago
Reply
RE: Need hex file for Simple Renard RGB+W for start address 5 (Channel 41)

Got my answer on the diychristmas.org site. Here's a link to the thread on that site. Hope this is able to help someone else out, too. Thanks, Mac!

11 years ago
Forum
Page 1 / 7
Share: