JCook
JCook
@jcook
Noble Member
Joined: Dec 18, 2013
Topics: 109 / Replies: 894
Reply
RE: Network routing between interfaces FPP v6.1

dkulp wrote:Supposedly the v5 firmware for the SanDevices fixes it. i was running v5.023 which is from a few years ago. I just updated it to v5.038...

4 years ago
Reply
RE: Network routing between interfaces FPP v6.1

freyesee wrote:I just use proxy, just go to the proxy setting on FPP and add the IP's to your controllers and save. we this worked ... kinda. It wo...

4 years ago
Reply
RE: Network routing between interfaces FPP v6.1

trying to connect to my E682 through the Pi. Pi is connected to home wifi. I edited my windows routing table, it looks correct. Can't get it to wor...

4 years ago
Topic
Reply
RE: Anyone Have Controllers in Stock?

Anyone know when the F16v4 will be in stock/available to order?

5 years ago
Reply
RE: Success Modifying VictorPV Sketch to Accept Renard Protocol from ESPixelstick

I tested the way Kev stated above first to make sure the ESP was communicating with the MEGA, then I used SacnView to send data over WiFi to test that...

5 years ago
Forum
Reply
RE: ESPixelStick with 3.2 firmware won't join WiFi

As a test, I set the IP address in the config file then flashed the ESP-01 which worked fine. just clicking the save button somehow corrupts the sett...

5 years ago
Reply
RE: Success Modifying VictorPV Sketch to Accept Renard Protocol from ESPixelstick

You can use To send data for testing. I have 12 LEDs on a breadboard and I can control them with this method. Also be sure you only GPIO 02 on the...

5 years ago
Forum
Reply
RE: ESPixelStick with 3.2 firmware won't join WiFi

i was trying to use the Arduino IDE but after 15-20 different failures of missing or multiple libraries .... I gave up!

5 years ago
Reply
RE: ESPixelStick with 3.2 firmware won't join WiFi

angus40 wrote: Try thisthread or search puya in forums. Also updating the Arduino IDE is a plus! I didn't use the Arduino IDE just the ESPSFlashToo...

5 years ago
Reply
RE: ESPixelStick with 3.2 firmware won't join WiFi

angus40 wrote:Do the Esp-01 modules you have, have the PUYA chip on them ? I recall there was an issue with them writing a save . so I bought 9 of ...

5 years ago
Reply
RE: ESPixelStick with 3.2 firmware won't join WiFi

I'm trying to use this firmware on a ESP-01 and it loads fine, connects fine with DHCP, when I try to set it to static it will not connect. I loaded...

5 years ago
Reply
RE: Zero Crossing Circuit

MartinMueller2003 wrote:That is not a zero cross detector circuit. That is a Triac Driver circuit. Most times the circuit is wired with what you have ...

5 years ago
Reply
RE: Zero Crossing Circuit

Re: Triac Circuit ThomasLED wrote:Just a couple observations: 1. From what I can see in your photo, red EL is incorrectly connected to the SCR's Ga...

5 years ago
Page 4 / 67