yes the 4th number can be any number however, you don't want it to match any other Ip on your network. My home network is setup so that my DHCP serve...
jeffu231 wrote:Check in the preview settings to make sure you have update locations turn on. Settings -> Update Location Properties. If that is not se...
Well...now you know what Ip address the E682 is. The issue seems to be that your home network is setup differently. Many will warn you NOT to have y...
So you can do some basic calcs. read the specs of your pixels to get its watts or amps. Also are you using 5v or 12v? a typical calc may look like ...
Why not try connecting direct to the E682 first, take the router out of the equation. If you think the E682 is 192.168.1.206 then set your computer t...
it appears it was a flaky pin in plug, got it sorted out
its a vertical string of 17px then a Male/female pigtail connector over to 40px horizontal. yup E682 stuff is right. I put a sting of 100 on the por...
MrDudeMan wrote:I have 6 short sequences (20 seconds) with no music that play randomly until someone sends an SMS. what setup are you using for SMS?
JP90 wrote:Jay after reading about the "zig" from jrossi3334 and now what you found I took a look at my E682 running my tree which is 35 pixels up and...
After reading Jrossi3334 post, I did another test. In my case I only need the “ First zig” and the “then every” I left at zero like I always have. W...
Jsw2488 sent me his profile folder. The issue was a couple elements didn't have color handling, see below. A couple appeared to have color handlin...
crisis_averted wrote:I have gutter lines that are 44.75 ft long. I'm using 5V pixel strings at 3" spacing, so each of these will need 180 pixels. I ca...
So I did some testing to piggy back off JP90 and found another bug. I have 4 columns, each has 2 sets of 48 pixels inside the HDPE. I setup the outp...
