Notifications
Clear all

wipe issue

6 Posts
2 Users
0 Reactions
2,209 Views
JCook
Posts: 1003
Topic starter
(@jcook)
Noble Member
Joined: 13 years ago
[#56403]

when I do a horizontal wipe left to right this string turns on first as if it is on the left. not sure why that's happening.

wipe

5 Replies
jeffu231
Posts: 2457
(@jeffu231)
Famed Member
Joined: 15 years ago

Check in the preview settings to make sure you have update locations turn on. Settings -> Update Location Properties. If that is not set, any additions will be at 0, 0 and have the behavior you are seeing.


Reply
JCook
Posts: 1003
Topic starter
(@jcook)
Noble Member
Joined: 13 years ago
jeffu231 wrote:Check in the preview settings to make sure you have update locations turn on. Settings -> Update Location Properties. If that is not set, any additions will be at 0, 0 and have the behavior you are seeing.

yes it is turned on


Reply
jeffu231
Posts: 2457
(@jeffu231)
Famed Member
Joined: 15 years ago

It feels like there has to be more than one preview item mapped to those same elements. I have seen something like this before. Each element only has one location and if there is more than one preview item mapped to it, the last one iterated when it assigns locations will win. If that last one is hidden on the left side, or upper left it could cause the same thing. It could be that there is something else that is sized very small and hard to see. You can try clicking on the string in the tree and see if you see something else light up in the preview setup to try and find it. Look close in the upper left.

If not, I may need to see the profile to figure it out.


Reply
JCook
Posts: 1003
Topic starter
(@jcook)
Noble Member
Joined: 13 years ago

jeff,

thanks, that is the issue. I have a front and a right side preview. That is the corning and I have that string in both previews. I knew better. I'm a bit rusty.


Reply
Page 1 / 2
Share: