Activity
 
Notifications
Clear all
Irrumater
@irrumater
Estimable Member
Joined: Dec 29, 2013
Topics: 23 / Replies: 74
Reply
RE: Setting up floods FPP/Xlights

Finally, back to this. I have setup 24v PSUs to inject power at the 1st and 3rd light as I has it last year and data/ ground coming from the Kulp and ...

1 year ago
Reply
RE: Setting up floods FPP/Xlights

I guess so. I purchased lights and PSUs from BST here back in 2023 and have used them all together since. I have started to incorporate pixels into my...

1 year ago
Reply
RE: Setting up floods FPP/Xlights

Sanity Check complete and it is def a power supply issue. I reconnected the PX1 to pc and old PS and everything worked. I then moved That setup and c...

1 year ago
Reply
RE: Setting up floods FPP/Xlights

I dug out the old Px1 this morning and sure enough it was wire as you suggested , v- and data from the controller and v+ from the meanwell, with groun...

1 year ago
Reply
RE: Setting up floods FPP/Xlights

Not sure I am smart enough to know what that means lol. I have a 3 wire pigtail connected to the kulp and the flood connected with the matching pigtai...

1 year ago
Reply
RE: Setting up floods FPP/Xlights

These are 3 wire floods not 4 wire. I am checking voltage from the + and - pins of the pigtail coming directly off the board and then also attaching t...

1 year ago
Reply
RE: Setting up floods FPP/Xlights

Getting 12.1 at the pigtail off the controller and rhe same coming out of the first flood. Also confirmed inout selector switch is set to 115. I wil...

1 year ago
Reply
RE: Setting up floods FPP/Xlights

These are 10w Ray wu style smart floods. The last 2 years I have run them off of Renard p1x and 2 125w meanwell powersupplys ( 2nd onw power i injwcte...

1 year ago
Reply
RE: Setting up floods FPP/Xlights

Test button from the Kulp provides the same results

1 year ago
Reply
RE: Setting up floods FPP/Xlights

When running test from FPP interface the light/lights connected to the port react in the behavior described. If I Cycle RGB I get BRIGHT RED, faint gr...

1 year ago
Topic
Replies: 22
Views: 4099
Reply
RE: Data feed to pixels

Thanks. With data only flowing one way I guess using 2 channels for the gutters would be the way to go. I have plans for power injection, based on cou...

1 year ago
Topic
Replies: 3
Views: 1127
Page 1 / 7
Share: