Irrumater
@irrumater
Estimable Member
Joined: Dec 29, 2013
Topics: 23 / Replies: 74
Reply
RE: Switching to FPP with Ren64 and PX1

This made a lot of progress. I had a 2nd controller setup initially but I think I had the Start/End channels incorrect and that was causing the incorr...

2 years ago
Reply
RE: Switching to FPP with Ren64 and PX1

memphislights2 wrote: Configured Com port is 4. It looks like you are setting up as Com port 5. What port shows up in device manager? The images ...

2 years ago
Topic
Replies: 5
Views: 1532
Reply
RE: Sudden issue with display using Ren64 and PX1

Finally got it working.... Well the display working. I remembered when I purchased the px1 I got 2 board just in case something like this happened. Sw...

2 years ago
Forum
Reply
RE: Sudden issue with display using Ren64 and PX1

Ok I am back on this finally. I have the ren 64 working, I dont think I did anything just let it set for a couple weeks and bam it worked, I don't lik...

2 years ago
Forum
Reply
RE: Sudden issue with display using Ren64 and PX1

Well i have plugged, unplugged, changed settings cut wires and reconnected. I am at a loss and frankly tired of messing with this halloween show. I di...

2 years ago
Forum
Reply
RE: Sudden issue with display using Ren64 and PX1

I checked that as I have had issues with it before. COMPort and settings in device manager match those in Vixen on configure port

2 years ago
Forum
Topic
Forum
Replies: 10
Views: 6083
Topic
Forum
Replies: 1
Views: 1348
Reply
RE: Renard64 and px1 matching baud rates

MartinMueller2003 wrote:Are you saying tat the PX1 is only driving 6 pixels and there will be two Ren64s and you want to run all of that on a single c...

3 years ago
Forum
Topic
Forum
Replies: 2
Views: 5742
Reply
RE: Trying to chain renard controllers for the first time

Sounds good. Thanks Guys for the help. I will look into getting a pickit3 ordered to make things easier at Christmas. I hope to be running off a Raspb...

3 years ago
Reply
RE: Trying to chain renard controllers for the first time

I think I found the issue. I don't think the baud rate is updateing on the px1. Seems as though no matter what I try to set it to it only matches up a...

3 years ago
Reply
RE: Trying to chain renard controllers for the first time

I have progress. Not sure what I have done , but by brute force of trying settings over and over I have the FE light off, the RX light on when connect...

3 years ago
Reply
RE: Trying to chain renard controllers for the first time

I am using a USB to Rs485 adaptor and cable. The cable currently works sending data to Ren64, and has worked going directly to the px1 but does not no...

3 years ago
Page 2 / 7