Last seen: Nov 17, 2026
I also use the Belkin and haven't had any issues with it impacting the lights. What's the distance from the controller to the Belkin and is anything e...
What's connected to that channel? Is the load higher than an amp? The DirkCheap SSRs can only handle about 1 Amp. It could also be solder joint anywhe...
Best or easiest? I set each one up as a single element and then patched it through an RGBW color filter. That way I didn't have to deal with the doubl...
I didn't see any problems with the profile if you are using COM4 on the computer and 57600 baud in the firmware.
+1 on naming colors. I'm red green color impaired and it would help me distinguish the colors. I have my family help me with colors initially, but th...
Do you have a multi-meter? Without AC powering the board, check some of the test points for voltage. Specifically, test TP1 to TP6, it should be 5v Te...
Here is the link to the RenardESP thread. There was also a group buy, and I'm sure there will be another. The device hangs off the ss24 and let's ...
The dev build #152 is now the non-dev build 3.2u2
The SS24 design is about the sweet spot for channel density. If you are interested in going to detached SSRs to provide a bit different topology, the...
If I understand correctly then the TR24's are also using an addressing scheme. Are they channels 1-24 and 25-48 ? Then one px1 should be 49-63 (15 cha...
Do your pulse or other effects show up ok? Check the color filter for the elements if they are single color, either delete the filter or make sure th...
I'm not familiar with the foxpup. Does fpp see it as two serial ports or just one? It sounds like the data is not going down the right com line from ...
Do the px1 know how many pixels you want them to drive? The default is 50, you need to set it to 200 otherwise they just discard or pass on the extra ...
In vixen could you patch it so it worked right? Patch element string 1 to channel 3451-3600, string 2 to 3450-3301 reversing elements, 3 to 3151-3300,...
