MikeKrebs wrote:Do you have a DMX dongle? Which one? That is setup in the controller section. You create elements that represent the things you want ...
I have Vixen open, but can't find any controller section to set up or sequence elements. Is there other hardware I need to buy, or does Vixen output c...
Excellent Mike! Very informative. Thanks for the info and diagram.
Thank you so much for all the input. I am stuck with using the DMX protocol since I have props that run on it that I want included in this setup. Thi...
This is what my new skull looks like in action. This is the 3D printed 3 Axis Animatronic skull that I will be replacing the old ones with soon:
I didn't answer all your questions in the above post. I use all servos and use ones from HiTec. Just a personal preference. Some are very powerful lik...
Yes, I do. I'll give you something to look over for a bit here: My 3 axis skull build That starts at the very beginning with my first design where I d...
Thanks for all the input. I may choose to support the forum. But this is secondary to me. I am mostly a Halloween guy. I have been in the Halloween se...
I didn't even see where that was an option. So it's an ongoing subscription? I don't think that interests me either.
I don't know exactly how the guy who does the spooky, scary skeletons video is doing the body motions, but it looks like there are only a couple of ac...
You could install some permanent posts with screw threads tapped into them in the side of the house. Short ones that don't stick out too far in places...
